Set-Up For Electrical Connections - Comunello Automation FORT 400 Manual Del Usuario

5 SET-UP FOR ELECTRICAL CONNECTIONS

ATTENTION! For connection to the mains, use a multicore cable provided for by legislation in force and as per the control
unit manual.
• Perform the manual unlock procedure as described in section 4.3.3.
• Unscrew the two side screws and pull the protective panel upwards (FIG. 4).
• Unscrew the ring cable lug located near the grommet (FIG. 22).
• Connect the cable lug to the yellow/green grounding cable (FIG. 23) (for class l models).
FIG. 22
• Screw the cable lug to the base as illustrated in FIG. 24.
• Guide the electrical wires to the electronic board located in the upper part of the gearmotor.
• Make the connections as described in the control unit manual.
• Cover the gearmotor with the protective panel again (FIG. 25).
FIG. 24
2
COMUNELLO ®Copyright 2020 - All rights reserved
FIG. 23
NOT INCLUDED
1
FIG. 25
33