Vornado 133 Manual Del Usuario página 6

CLEANING
GRILL REMOVAL (MODELS 533, 633, 683, 753)
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing grill.
1. Remove the 3 screws located in between
the ribs of the inlet grill at roughly 10, 2,
Front Grill Clip
and 6 o'clock positions. Screw locations are
’
also indicated with an arrow* ( ) on the
circulator. Do Not remove the 2 screws
on the pivot arms. Release the Front Grill
Clips located at the 2, 5, 7 and 10 o'clock
positions.
2. Dust or wash Front Grill with a mild dish-
washing soap. Do not place grill in the
dishwasher. The excessive heat can distort
the plastic.
3. To reattach - align the Front Grill Clips with
the holes and firmly snap each clip back
Front Grill Clip
into place. Replace all the screws.
*Model 753 does not have arrow indicators.
Use the brush attachment on your household
vacuum cleaner to vacuum any accumulated
dust off the Front Grill and Air Inlets.
10 English
Screwdriver required.
Screw
Screw
CLEANING
BLADE REMOVAL
WARNING: To reduce the risk of electrical shock and injury to persons, unplug the circulator before removing blade.
1. First, remove the nut from the shaft
by turning the nut clockwise to
Front Grill Clip
loosen. Pull the blade straight out
from the shaft.
Screw
2. Wipe the Blade with a damp cloth.
If your circulator is used in a greasy
environment, such as a kitchen,
Note: The motor
mild soap or a common household
is permanently
cleaner may be necessary. Do not
lubricated and
use solvents. Do not place blade in
requires no oiling.
the dishwasher. The excessive heat
can distort the plastic.
3. To reattach - be certain the flat
side of the shaft aligns directly with
Front Grill Clip
the corresponding flat side on the
blade's socket. Push the blade all
the way on the shaft until it bottoms
out. Do not use a hammer as this
could result in bearing damage.
Reinstall nut.
Pliers required.
Remove Nut
Clockwise
11
English