Machine Use - Craftsman CMEW020 Manual De Instrucciones

English
Fig. Y
KniVEs AT CORRECT hEighT
MATERiAl
OUT-FEED
TABlE
Cutterhead Guard (Fig. Z)

WARNING: Keep hands away from the
cutterhead during use.

WARNING: Do not remove the cutterhead guard, do
not block the cutterhead guard, make sure cutterhead
guard spring back freely and touch the fence.
The cutterhead guard 2 is designed to rest against the
fence 1 . It will automatically move as the workpiece is
advanced toward the cutterhead and spring back against
the fence after the workpiece passes the cutterhead. With
the jointer off check for proper position and motion prior to
each operation. Always use the cutterhead guard.
Fig. Z
2
Chip and Dust Chute (Fig. AA)

WARNING: Keep hands out of chip and dust chute
at all times.
A chip and dust chute 10 is provided on the outfeed end of
the jointer base for efficient chip removal.
10
in-FEED TABlE
CUTTER
1
Fig. AA
10
Push Blocks (Fig. BB)
A set of push blocks 39 is supplied with your jointer
and should be used whenever possible to minimize all
danger to your hands. Fig. BB illustrates using the push
blocks properly.
Fig. BB

MACHINE USE


WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.

WARNING: Always use cutterhead guard and keep
hands away from cutterhead. Use push blocks
whenever possible.
The following directions will give the beginner a start on
jointer operations. Use scrap pieces of lumber to check
the settings and to get the feel of the operations before
attempting regular work.
nOTE: The knives on the jointer will not wear evenly by
feeding the wood through the same spot on the table every
time. Feed the wood through the jointer at different spots
on the table to help eliminate uneven wear of the knives.
39