Tabla de contenido
Idiomas disponibles
Idiomas disponibles
English
Fig. FF
MiniMUM AnD
MAXiMUM PlAning
DiMEnsiOns
1/2"
(12.7 mm)
3/4"(19 mm) MINimum
MINIMUM
6"
(152.4 mm) MAXIMUM
Direction of Grain (GG, HH)
Avoid feeding work into the jointer against the grain. The
result will be chipped and splintered edges. Feed with the
grain to obtain a smooth surface.
Fig. GG
CORRECT FEED - WiTh ThE gRAin
MATERiAl
OUT-FEED
TABlE
CUTTER
Fig. HH
WROng FEED -
AgAinsT ThE
gRAin
OUT-FEED
TABlE
MAINTENANCE
WARNING: To reduce the risk of serious personal
injury, turn unit off and disconnect it from
power source before making any adjustments or
removing/installing attachments or accessories.
An accidental start-up can cause injury.
Belt Replacement (Fig. II, JJ)
When it becomes necessary to replace the belt on
your jointer:
1. Remove screw
using hex wrench supplied, and
40
remove belt guard
41
.
2. Loosen three screws
42
remove belt
43
from pulleys.
3. Assemble new belt to the cutterhead and motor pulleys.
Press down on motor pulley
tighten three screws.
nOTE: There should be approximately 1/4" (6.4 mm)
12
in-FEED TA BlE
MATERiAl
in-FEED TABlE
to release belt tension and
44
to tension belt and
deflection in the belt
43
pulleys using light finger pressure. The belt does not
require excessive tension to function properly.
4. Replace belt guard
41
.
Fig. II
Fig. JJ
42
Failure to Start
Should your machine fail to start, check to make sure the
prongs on the cord plug are making good contact in the
outlet. Also, check for blown fuses or open circuit breakers
in the line.
Troubleshooting
For assistance with your machine, visit our website at
www.craftsman.com for a list of service centers or call the
help line at 1-888-331-4569.
Accessories
WARNING: Since accessories, other than those
offered by CRAFTSMAN, have not been tested with
this product, use of such accessories with this tool
could be hazardous. To reduce the risk of injury, only
CRAFTSMAN recommended accessories should be
used with this product.
Recommended accessories for use with your tool are
available at extra cost from your local dealer or authorized
service center. If you need assistance in locating any
accessory, please contact CRAFTSMAN, call 1-888-331-4569.
at the center span of the
41
40
44
42
43
Tabla de contenido
