Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Safety
READ AND FOLLOW
SAFETY INSTRUCTIONS!
This is the safety alert symbol. When you see this
symbol on your pump or in this manual, look for one of
the following signal words and be alert to the potential for
personal injury:
warns about hazards that will cause serious
personal injury, death or major property damage if ignored.
warns about hazards that can cause serious
personal injury, death or major property damage if ignored.
warns about hazards that will or can cause
minor personal injury or property damage if ignored.
The label NOTICE indicates special instructions which are
important but not related to hazards.
Carefully read and follow all safety instructions in this
manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety labels.
1. Read this manual carefully. Failure to follow these
instructions could cause serious bodily injury and/or
property damage.
2. Check your local codes before installing. You must
comply with their rules.
NOTICE: This pump does not require a connection to a
main stack vent, per the National Standard Plumbing Code
(NSPC) 2003 Section 11.7.9.
Hazardous voltage. Can shock, burn or
cause death. Unplug pump before working on it.
DESCRIPTION
This pump is designed to be used with a sink where a grav-
ity drain line is not available. Attach the pump to the drain
tail piece; the pump will start when water begins to drain.
Uses include basement laundry sinks, wet bars and utility
sinks.
SPECIFICATIONS
Power supply required ....................................115V, 60 HZ.
Liquid Temp. Range....................... 32° – 120°F (0° – 50°C)
Individual Branch Circuit Required (min.)..............15 Amps
Pump Inlet...........................................................1-1/2" NPT
Pump Discharge........................................................1" NPT
Fire or explosion hazard. Do not use in
explosive atmospheres. Pump water only with this pump.
INSTALLATION
(SEE FIGURES 1 AND 2)
Electric Shock Hazard. Plug pump into a
properly grounded, GFCI protected outlet. Do NOT plug in
the pump until after it is completely installed.
Parts supplied with the pump:
• Pump Assembly
• Fiber gasket and O-Ring
• 1" NPT to Slip (Glued) Outlet Adapter
• One-way valve (check valve)
• Discharge shut-off/flow balancing valve.
• Strainer Cup
• 90° Elbow (slip both ends)
Parts purchased separately:
• 1" PVC drain piping including plastic pipe cement and
any required fittings and adapters.
Sink Tail Piece
Fiber Gasket
Sink Bottom
and Drain Port
Lock Ring for
Tail piece
Union Lock
Ring
Union Mating
Ring (thread onto
Sink Tail Piece)
Union Mating
Ring (thread onto
Close Nipple)
Close Nipple
Pump Inlet
Port
Figure 1: Typical method of mounting the pump on the
sink.
Sink Bottom with Drain Port;
Tail Piece integral with Sink
Fiber
Gasket
O-Ring
5324 0406
2
Tabla de contenido
