Inclination / Machine Cycle Operation; Lever For Machine Cycle Operation; Brush Lifting/Lowering Pedal - Ghibli & Wirbel ROLLY 7 1/2 Uso Y Mantenimiento

39) Led indicating the maximum level of
the recovery water
- It turns on when the level of water from
the recovery tank has reached the maxi-
mum level; when reaching the maximum
level, the turned on LED (39) means that
the machine turns off.
34) Battery charge status LEDs
- The LEDs (34) indicate the battery char-
ge status.
Led 34a = low battery.
Led 34b = low battery, please recharge
the battery.
Led 34c = battery full.
- When the battery is low, the yellow LED
(34b) turns on, and the machine has a
range of a few minutes until the red LED
(34a) flashes and the brush stops revol-
ving; charge the battery before turning off
the machine (red LED 34a turns on stea-
dy).
40) LED indicating the excessive pressu-
re of the brush.
- When it turns on, it indicates that there
is an excessive ground pressure of the
brush caused by the type of flooring or
by the incorrect adjustment, therefore it
is necessary to reduce the pressure by
pressing the appropriate selector as indi-
cated in the corresponding paragraph.
6.2 LEVER (3) FOR THE
ADjUSTMENT OF THE
HANDLE BAR
INCLINATION / MACHINE
CYCLE OPERATION
(FIG. 11)
- With the machine turned off, by pulling
the lever (3) it is possible to change the
position of the handle bar (1);
by releasing the lever, the handle bar is
positioned and blocked in the position it
is found.
- With the machine turned on, by pulling
and holding the lever (3), it starts the wor-
king cycle and it is possible to change the
position of the handle bar (1) so that it will
be possible to clean under the tables as
well;
by releasing the lever, the cycle closes
and the handle bar is positioned and blo-
cked in the position it is found.
6.3 LEVER (4) FOR
MACHINE CYCLE
OPERATION (FIG. 10-11)
- By pressing the levers (4) with the LED
(31) turned on, the working cycle starts;
if the lever is released, the working cycle
stops.
6.4 BRUSH
LIFTING/LOWERING
PEDAL (FIG. 12)
- By moving the pedal (10) towards the
inside part of the machine, the pedal is
lifted, in position "S", the brush and the
wipers are lowered into the working posi-
tion.
- By pressing the pedal (10) and slightly
moving it towards the external part of the
machine, the pedal is blocked into the po-
sition "P", the brush and the wipers are in
lifted, parking or moving position.
ENGLISH - 8
www.ghibliwirbel.com
Professional Cleaning Machines Since 1968