Fan Alignment And Hanger Bracket Installation (For Canadian Installation Only) - Fanimation Caruso FP7000 Serie Manual Del Propietário

Fan Alignment And Hanger Bracket Installation (For Canadian Installation Only)

INSTALLATION NOTE
Be sure that the safety cable (along with the electrical
supply wires) is pulled through the downrod when
installing the downrod to the support bar.
4. Position the bottom end of the downrod inside the
housing support located at the center of the support bar
assembly. It may be necessary to loosen the two screws
that go through the crossbar assembly if the downrod does
not slide into the housing support easily without scratching
the fi nish. Connect the downrod to the housing support
using the ¼˝ x 2 ⁄ ˝ socket head bolt and locking nut.
3
16
Securely tighten both bolt and nut. (Figure 3)
5. Slide Canopy over the downrod. (Figure 4)
6. Route wires and safety cable though the Hanger Ball
Assembly.
7. Assemble the Hanger Ball Assembly to top of the
downrod with the set screw. (Figure 4)
8. Before installing fan, measure up approximately 6-9
inches above the top of the downrod. Cut off excess wire
and strip back insulation ½˝ from end of wire.
9. Hang the support bar / downrod assembly (assembled
earlier) into the the hanger bracket. Make sure the groove
of the hanger ball is positioned on the tab of the hanger
bracket. (Figure 5)
10. Carefully ROTATE the Hanger Bracket and support
bar / downrod assembly together to orientate the fan in the
desired position. (Figure 5)
11. Carefully remove the support bar / downrod assembly
from the Hanger Bracket.
12. NOW, securely and fully tighten the lag bolt in the
center of the Hanger Bracket while being careful not to
allow the Hanger Bracket to rotate. (Figure 6)
Housing
Support
Downrod
Setscrew
Tab
Figure 5
7
Downrod
Loosen
Loosen
Figure 3
Pin
Hanger Ball
Assembly
Canopy
Figure 4
Rotate both Hanger
Bracket & Crossbar/
Pole assembly
together
Figure 6