Blade Attachment; Housing Switch Cup / Adapter Plate Assembly - Fanimation Caruso FP7000 Serie Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

INSTALLATION NOTE

Attach the fan blades after hanging the fan body and

wiring the fan to prevent blade breakage or damage.

1. Blade holders come packed in two different bundles, one

blade holder set is marked with a red dot (5 pcs) and one

blade holder set is marked with white dot (5 pcs). These

colored dots indicate which motor switch set-up (red or

white dot) to attach these blade holders to.

2. Using the (blade holder to hub) cap screws attach the

blade holders to the corresponding motor assembly

which also will be switched with a white or a red dot.

NOTE: Assemble with Hand Tools Only!

3. Make sure the screws securing the blade holders to

the hub are secure and that the blade holders are properly

seated on the hub (Figure 1).

Housing Switch Cup / Adapter Plate Assembly

INSTALLATION NOTE

This section is applicable after the fan and the blades are

completely installed.

Housing Switch Cup/Adapter Assembly:

1. Disassemble the Housing Switch Cup/Adapter assembly

by removing three screws. (Figure 1a)

2. Loosen two screws and remove one screw from Housing

Support Bracket.

3. Assemble the Adapter Plate assembly on the Housing

Support Bracket by rotating plate and properly positioning

screws in key slots. Install third screw in remaining hole.

Fully tighten all three screws. (Figure 1b)

4. Securely attach the 9-pin Switch Cup connector to wiring

harness socket within Adapter Plate assembly.

(Figure 1b)

5. Assemble the Housing Switch Cup onto the assembled

Adapter Plate with three screws. (Figure 2)

6. Repeat above steps for the second motor assembly.