Wiring And Control Options; How To Wire Your Ceiling Fan - Fanimation Caruso FP7000 Serie Manual Del Propietário

Please choose one of the following options and proceed to
the page as indicated.
1. Standard 4-position, 2-speed, fan-only CW3WH-CA wall
control, see page 9.
2. Optional fan & light slide wall control (C6). Please see
instructions provided with control.
NOTE: If you are using a Fanimation Light Fixture with your fan, see Ceiling Fan Light Kit Installation Instructions (packed
with light kit) for wiring.
If you feel that you do not have enough electrical wiring
knowledge or experience, have your fan installed by a
licensed electrician.
▲WARNING
To avoid possible electrical shock, be sure electricity is
turned off at the main fuse box before wiring.
NOTE: If you are not sure if the outlet box is grounded,
contact a licensed electrician for advice, as it must be
grounded for safe operation.
1. Run the blue, black and white fan wires through the
wiring hole in the side of the hanger bracket to allow for
electrical connections.
2. Connect the green grounding wire from the hanger
bracket and hanger ball to the grounding wire from the
outlet box (this may be a bare wire or a wire with green
insulation). Securely connect these three wires with wire
connector supplied with your fan.
3. Securely connect the white wire from the fan motor
to the white supply (neutral) wire using wire connector
supplied (Figure 1).
4. Securely connect the black fan motor wire and blue
wire to the black supply wire using wire connector supplied
(Figure 1).
NOTE: If you are using a Fanimation Light Fixture with
your fan, see Ceiling Fan Light Kit Installation Instructions
for proper wiring.
INSTALLATION NOTE
If separate control of light fixture (optional) is desired,
a separate switch leg from the outlet box is required. In
this instance the blue wire from the fan will be connected
to the light switch leg (typically red wire)

Wiring and Control Options

How to Wire Your Ceiling Fan

3. Optional fan & light remote control receiver unit (SW70),
to be used in conjunction with: C24 hand-held remote
control and/or C25 wall-mount remote control Please see
instructions provided with control.
120 VAC
White
Supply
(Neutral)
(User
Supplied)
5. After connections have been made, turn leads upward
and carefully push leads into the outlet box, with the white
and green leads to one side of the box and the black and
blue leads towards the other side.
6. After all electrical connections are made, secure the
ceiling canopy to the hanger bracket with the threaded
rods, lockwashers and knurled knobs provided (see page
10).
7. Blades are attached prior to attaching switch caps.
▲WARNING
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors, except for the ground wire. Do not operate
fan until the blades is in place. Noise and fan damage
could result.
10
Black Wire (Hot)
Green Wire
(Ground)
(To/From
mounting
bracket)
Blue Wire
(Light
Fixture)
Figure 1