Tabla de contenido
DE
Montageanleitung
FR
Instructions de montage
IT
Istruzioni di montaggio
- Mount the pump on a solid surface and in a position comfortable for filter cleaning and
routine maintenance. The pump can be installed in any position, in the event of installation in
vertical position put the motor above the hydraulic part.
- Mount the pump near the water tank in order to obtain the best performance.
- Despite the anti-vibration base kit is recommended to connect input and output of the
pump through a min. 0.5mt. and diameter 1/2 "(13mm.) flexible pipe in order to attenuate the
vibrations that otherwise the pump would send to the hydraulic system causing noise.
- For proper operation of the pump install at the entrance of the same the Fiamma filter or a
EN
filter with a 13 mm. minimum passing and not less than 36 mesh.
- The installation of the Fiamma A20 expansion tank within the first meter of the implant
optimizes and stabilizes the performance of the product.
- The pump is designed only for intermittent use and for contact with drinking water, any
other use may cause undesired operation.
- Prepare for the electrical connection a dedicated circuit with a cable of 16AWG 1.5mm ²
minimum section protected by 7.5 A and 15 A switch located on the positive cable.
- When using for the first time, it's advisable to proceed with the sanitation so as to remove
any processing waste.
DE
Wartung
FR
Entretien
IT
Manutenzione
- Check periodically the cleaning of the inlet filter or in the event of low flo.
- Remove the power supply during the non-use of the product.
- During winter storage if outdoor temperatures are expected <0 ° C it is absolutely
necessary to drain the entire plumbing system, especially the pump by disconnecting the
vacuum hose and making it run for a few minutes as long as no water comes out from all the
EN
taps .
- To ensure the proper operation of the pump and of the plumbing system is recommended
to make the sanitization of the same at least once a year or after a long period of non-use of
the product.
- Periodically check the tightness of the hydraulic components that vibrations may have
loosened.
EN
Installation instructions
ES
Instrucciones de montaje
EN
Maintenance
ES
Mantenimento
COMFORT
11
Tabla de contenido
