V-TAC VT-524-S Instrucciones De Instalación página 2

WARNING:
1. Please make sure to turn off the power before starting the installation.
2. Installation must be performed by a qualified electrician
3. The light source of this luminaire is not replaceable; when the light source reaches its end of life the
whole luminaire shall be replaced.
This marking indicates that this
product should not be disposed
of with other household wastes.
MAINTAINED
Ls N
For Maintained Operation - Maintained operation, link L (Switched Live) to terminal Ls (permanent Live).
If 'Ls' is not connected, the fitting works as non-maintained
All self-contained emergency lighting luminaires require a continuous (un-switched) 220V-240V single
phase 50hz (L) supply to keep the inbuilt batteries charged.
Note: the LEDs contained in this fitting are not designed to be replaced.
INSTALLATION OF THE FITTING
Installation should only be carried out in accordance with the current edition of the "Regulations for Electrical
Installations" EN61547 and with the requirements of BS EN 60598-1.
Don't do a high voltage insulation test on the luminaire as this may damage the control gear.
Before starting the installation ensure that the electricity supply is isolated and that it cannot be reenergized
accidentally.
1) Remove the front diffuser from the body by removing the 2 fixing screws.
2) Release the gear tray by easing the plastic clips away from the tray and by lifting the tray away from the
base.
3) There are four cable entry holes on this fitting. One on the rear and one on each side of the plastic body.
Drill out the intended cable entry hole suitable for your installation.
NON-MAINTAINED
L
Caution, risk of electric shock.
Ls N L
ENGLISH