Stanley ST-221A-240-E Manual De Instrucciones página 4

ENGLISH
FEATURES
ST-221A-240-E
OPERATION
• Position the fan heater so that it stands upright on a firm,
level surface and at a safe distance from wet environments
and flammable objects.
• Connect the fan heater to the proper electrical power.
• Set the thermostat dial to the maximum temperature.
• The fan heater will switch on when the function dial is set
to one of the two power settings.
• Once the room reaches the desired temperature, turn the
thermostat dial back until heating element turns off.
SETTING
NOTE: THE FAN WILL RUN CONTINUOUSLY WHILE THE HEATER IS OPERATING
Automatic Overheat Safety Control
• This heater is equipped with safety internal heat limiting
thermostat and an overheat protection circuit. When a
potential overheat temperature is reached, the system will
automatically shut the heater off.
3
Indicator
Thermostat
Control Dial
Function
Control
Tip-Over
FUNCTION
UNIT IS OFF
FAN RUNS - NO HEATING
FAN RUNS - HALF POWER HEATING
FAN RUNS - FULL POWER HEATING
Electric Fan Heater (ST-221A-240-E / ST-222A-240-E)
Power
Light
Dial
Hot Air
Outlet
Switch
Thermostat Instructions
• Set the thermostat to MAX and let the heater operate with
full power input. When the room temperature reaches the
required temperature, turn the thermostat to the left until
it switches off.
• The thermostat will then switch on and off automatically
to control the room temperature according to the preset
value and keep the room temperature constant.
NOTICE: When using the heater for the first time, you
may notice a slight emission of smoke. This is normal
and will stop after a short time. The heating element is
made of steel and was coated with a layer of protective
oil during production. The smoke is caused by the
leftover oil as it is heated.
ST-222A-240-E