Wear Parts - Oase PondJet Eco Instrucciones De Uso

- EN -
How to proceed:
 J
Turn the filter basket counterclockwise and remove.
– The filter basket is fastened to the pump with a bayonet lock.
Clean all parts.
– Use a soft brush.
– Rinse parts in clean water.
Reassemble the unit in the reverse order.
Replacing impeller unit
Note!
The impeller unit contains strong magnets that attract magnetic particles (e.g. iron filings).
 All particles must be removed from the impeller unit before reassembly. Any remaining particles can
cause irreparable damage to the impeller unit and motor block.
Prerequisite:
 The pump is dismantled.
 Assembling the pump. Disassemble in the reverse order.
How to proceed:
 K
Turn the filter basket counterclockwise and remove.
– The filter basket is fastened to the pump with a bayonet lock.
Remove the four screws and remove the pump casing together with the intermediate casing.
Pull out the impeller unit and replace if necessary.
– Use a wide-blade screwdriver to carefully lever out the impeller unit if necessary.
Reassemble the unit in the reverse order.

Wear parts

The impeller unit is a wearing part and does not fall under the warranty.
Storage/Over-wintering
The unit is frost resistant to minus 20 °C. Should you store the unit outside of the pond, clean it thoroughly with a soft
brush and water, check it for damage, then store immersed in water or filled with water. Do not immerse the power plug
in water!
Repair
Repair is not possible in the following cases. The pump has to be replaced.
 If there is no replacement part approved by OASE for a defective component.
 If an electric cable permanently connected to the pump becomes damaged.
Disposal
Do not dispose of this unit with domestic waste! For disposal purposes, please use the return system provided.
Disable the unit beforehand by cutting off the cables.
18