Kohler STERLING 5900 Serie Guia De Instalacion página 12

Bushing
12. Install the Pile Seal
Install a bushing into one end of the inside panel guide.
Measure the length of the panel guide, subtract 1" (2.5 cm), then cut the pile seal to the resulting
length.
Slide the pile seal into the panel guide.
Install a bushing into the other end of the panel guide.
Use a pliers to crimp each end of the panel guide to keep the bushings from sliding off.
13. Install the Panel Guide
NOTE: Perform these installation steps from inside the shower.
Install the panel guide in the opening of the bottom track.
Align the slots on the panel guide with the holes in the inside panel bottom frame.
Loosely thread two #8-18 x 3/8" panhead screws through the guide and into the frame. Do not
tighten at this time.
Push the panel guide all the way into the bottom track.
Lower the guide slightly for clearance and tighten the screws.
Move the panel back and forth along the full width of the opening.
If the panel sticks, loosen the screws and adjust the guide. Repeat until the door operates smoothly.
Install screw covers over the panel guide screws.
Install screw covers over the four frame screws at the bottom of the panels.
1034033-2-B
Inside Panel
Guide Bushing
Installed
Inside Panel
Guide
Pile
Seal
Bushing
Crimp here on
each end.
Inside
Panel
Panel
Frame
Screw
Inside
Panel
Guide
12
#8-18 x 3/8"
Panhead
Screw
Screw
Cover
Screw
Cover
Sterling