Idiomas disponibles
Idiomas disponibles
3 94 10 006 000 - Buch Seite 13 Freitag, 20. Oktober 2006 8:31 08
GICS
Never touch the running grinding belt. Dan-
ger of injury.
Press the emergency-off switch immediately in
danger situations. The machine runs on for up to
50 seconds.
Clean the ventilation slots of the machine regu-
larly. The motor fan draws dust into the housing.
Excessive accumulation of metal dust can cause
electrical dangers.
The mains plug of the machine may be mounted
only by a qualified electrician. The protective
conductor in the mains socket outlet must be
connected with the protective earthing of the
mains supply.
Pull out the mains plug for maintenance and
repair! Switching the machine on unintentionally
can lead to serious injuries.
Have the electrical safety of the machine checked
regularly in accordance with statutory regula-
tions. For machines that have not been checked,
there may be danger of electrical shock!
Check the rotation direction of the motor before
starting the operation of the machine for the first
time. If the rotation direction of the motor is
incorrect, the workpiece can be thrown from
the machine and cause an accident. The rotation
direction may be changed only by a qualified
electrician.
Always work with great attention and care, espe-
cially when guiding in and removing the working
material. Diminishing attention can lead to seri-
ous injuries of your hands.
Be careful when working short or thin material.
When guiding in and removing, the grinding belt
or the brake wheel can catch hold of your hands
and cause serious injuries.
Be careful after switching off. The machine will
run on for approx. 1 minute. Carry out adjust-
ments and maintenance only when the grinding
belt has come to a complete stop.
At a glance.
1 On/Off switch, grinding belt
2 On/Off switch, brake wheel
3 Selector switch, belt speed
4 On/Off switch, coolant pump
5 Emergency OFF pushbutton
6 Plug
7 Crank for height adjustment of guide rail/
guide roller
8 Scale for height adjustment of guide rail/guide
roller
9 Instruction label, table with setting values
10 Lever for applying the brake wheel to the work
piece
11 Drive motor for brake wheel
12 Valve for coolant supply
13 Crank for brake wheel clearance
14 Star-knob bolt for brake wheel parallelism
15 Star-knob bolt for brake wheel inclination
16 Guide rail
17 Levelling mount for height adjustment
18 Star-knob bolt for adjusting the tracking
of the grinding belt
19 Cover
20 Drive wheel
21 Brake wheel
22 Contact wheel
23 Belt tensioning lever
24 Drain cock
25 Adjustment screws for guide rail
26 Adjustment screws for guide rail
27 Adjustment screws for guide roller
28 Drum with guide elements
29 Drum lock
30 Guide roller
31 Cleaning opening
Intended use of the machine.
The GICS cylindrical belt grinder is intended
exclusively for grinding and polishing of steel
pipes, light metal pipes as well as for solid round
steel bars with diameters ranging between
D = 10 – 160 mm.
EN
13
