Tabla de contenido
DRILL CHUCK REPLACEMENT
Open chuck (1) jaws.
Unscrew the chuck fixing screw with cross screwdriver, by turning it clockwise (left-hand thread).
Install hex key in the chuck (fig. D).
Gently tap free end of the hex key.
Unscrew the chuck.
Installation of the chuck is similar to deinstallation, only the sequence of actions is reversed. Drill chuck
must be firmly screwed with approx. 30 - 35 Nm torque. Check drill chuck regularly against damages.
REPLACEMENT OF CARBON BRUSHES
Replace immediately used up (shorter than 5 mm), burnt or cracked motor carbon brushes. Always
replace both brushes at a time.
Entrust replacement of carbon brushes only to a qualified person. Only original parts should be
used.
All faults should be repaired by service workshop authorized by the manufacturer.
RATED PARAMETERS
Parameter
Supply voltage
Current frequency
Power consumption
No load rotational speed
Clamping range
Spindle thread
Maximum drilling diameter
Strokes per minute
Protection class
Weight
Year of production
NOISE LEVEL AND VIBRATION PARAMETERS
Sound pressure: Lp
= 96,3 dB(A) K = 3 dB(A)
A
Sound power: Lw
= 107,3 dB(A) K = 3 dB(A)
A
Vibration acceleration: a
h
Do not dispose of electrically powered products with household wastes, they should be utilized in
proper plants. Obtain information on wastes utilization from your seller or local authorities. Used up
electric and electronic equipment contains substances active in natural environment. Unrecycled
equipment constitutes a potential risk for environment and human health.
* Right to introduce changes is reserved.
"Grupa Topex Spółka z ograniczoną odpowiedzialnością" Spółka komandytowa with seat in Warsaw at ul. Pograniczna 2/4 (hereinafter Grupa
Topex) informs, that all copyrights to this instruction (hereinafter Instruction), including, but not limited to, text, photographies, schemes,
drawings and layout of the instruction, belong to Grupa Topex exclusively and are protected by laws accordingly to Copyright and Related
Rights Act of 4 February 2004 (ustawa o prawie autorskim i prawach pokrewnych, Dz. U. 2006 No 90 item 631 with later ammendments).
Copying, processing, publishing, modifications for commercial purposes of the entire Instruction or its parts without written permission of
Grupa Topex are strictly forbidden and may cause civil and legal liability.
TECHNICAL PARAMETERS
steel
wood
concrete
= 15,31 m/s
2
K = 1,5 m/s
2
ENVIRONMENT PROTECTION
Drill
230 V AC
0-3000 rpm
1,5-13 mm
1/2''x 20 mm
10 mm
25 mm
13 mm
0-48000 spm
15
Value
50 Hz
650 W
II
2 kg
2016
Tabla de contenido
