Intended Use - Worx WX255 Manual Original

Vibration emission value: a
Uncertainty K = 1.5 m/s²
The declared vibration total value and the declared noise
emission value have been measured in accordance with a
standard test method and may be used for comparing one tool
with another.
The declared vibration total value and the declared noise
emission value may also be used in a preliminary assessment
of exposure.
WARNING: The vibration and noise emissions during
actual use of the power tool can differ from the declared
value depending on the ways in which the tool is used
especially what kind of workpiece is processed dependant on
18
the following examples and other variations on how the tool is
used:
How the tool is used and the materials being cut or drilled.
The tool being in good condition and well maintained.
The use of the correct accessory for the tool and ensuring it is
sharp and in good condition.
The tightness of the grip on the handles and if any anti vibration
and noise accessories are used.
And the tool is being used as intended by its design and these
instructions.
This tool may cause hand-arm vibration syndrome if its
use is not adequately managed.
WARNING: To be accurate, an estimation of exposure
level in the actual conditions of use should also take
= 0.70 m/s
2
h
account of all parts of the operating cycle such as the times
when the tool is switched off and when it is running idle but not
actually doing the job. This may significantly reduce the
exposure level over the total working period.
Helping to minimise your vibration and noise exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these instructions and
keep well lubricated (where appropriate).
If the tool is to be used regularly then invest in anti vibration
and noise accessories.
Plan your work schedule to spread any high vibration tool use
across a number of days.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the instruction book
carefully.

INTENDED USE

The power tool is intended for driving in and loosening screws
as well as for drilling in wood, metal and plastic.
ACTION
BEFORE OPERATION
FIGURE