Preparing For Use; Setting The Temperature - Philips GC8215/01 Manual De Instrucciones

EnGlish
8
On On

preparing for use

1 Place the steam generator on a stable and level surface, e.g. on the
hard part of the ironing board or on a table.
Filling the detachable water tank
You can refill the water tank at any time during ironing.
Do not put hot water, perfume, vinegar, starch, descaling agents, ironing
aids or other chemicals in the water tank.
Do not overfill the water tank, otherwise water may spill out of the
filling opening when you reinsert the water tank.
1 Remove the detachable water tank from the steam generator.
 Fill the water tank with tap water up to the MAX indication.
Note: If the tap water in your area is very hard, we advise you to mix it with an
equal amount of distilled water.
 Slide the water tank back into the steam generator ('click').
Note: If the water tank is not properly placed, the iron does not produce any
steam.

setting the temperature

1 Check the laundry care label of the article to be ironed to
determine the required ironing temperature
- 1 for synthetic fabrics ( e.g. acrylic, viscose, polyamide) and silk
- 2 for wool
- 3 for cotton
- MAX for linen
 To set the required ironing temperature, turn the temperature dial
to the appropriate position.
 Put the mains plug in an earthed wall socket and set the on/off
switch to 'on'.
The power-on light in the on/off switch goes on.
,
The temperature light on the iron goes on.
,
When the iron has reached the set temperature, the temperature
,
light goes out.
Note: During ironing, the temperature light goes on from time to time. This
indicates that the iron is heating up to the set temperature.