Kohler Devonshire K-394 Guia De Instalacion página 6

Stopper
Body
Stopper
Nut
Nut
Rod
Seal
Body
Seal Hole
Tailpiece
Apply 3 layers of
sealant tape and
a small bead of
pipe sealant to
threads
4. Drain Installation–Style A
- Remove any excess putty or sealant.
- Insert the stopper into the flange.
- Insert the seal into the body seal hole. Insert the short end of the rod
into the body seal hole and under the stopper for regular
installations. For vandal resistant installations, fit the rod through
the hole in the stopper. Secure with body nut.
- Remove and adjust the stopper so it lifts about 3/8" (1cm) when
opened. To adjust, loosen the stopper nut and shorten or lengthen
the stopper as needed. Tighten the stopper nut.
- Apply three layers of thread tape and a small bead of pipe sealant to
the tailpiece threads. Thread the tailpiece to the body and tighten
securely.
- Slide one end of the clip onto the rod. Slide the link onto the rod
with the thumb screw facing the back of the lavatory.
- Squeeze the other end of the clip, aligning the hole with the rod.
Move the link to the proper position by squeezing the clip and
sliding it along the rod.
- Insert the lift rod into the hole in the faucet and then into the hole in
the link.
- Tighten the thumb screw on the link so the lift rod knob extends
1/2" (1.3cm) above the lift rod hole.
A
1012739-2-
Lift Rod
Faucet
Rod
Clip
Style A
continued
6
1/2"
(1.3cm)
Thumb
Screw
Link
Kohler Co.