Triton Blue 24/48 TR C 2448 Manual De Usuario página 7

Record Code.
When you've entered a new Record Code the first time, and now you want to
cancel the new Record Code, you may press and hold down the Record and
Exit buttons at a time to exit.
1.3 Program Scenes
1) Record Enable.
2) Select the 1-48 Single mode by tapping the Mode Select button. This will give
you control of all 48 channels as you program.
Be sure that Master A & B are both set at maxium.(Master A is at its maximum
in the fully up position, while Master B is at its maximum in the fully down
position.)
3) Create a desired scene using Channel Sliders 1-48. At 0% or DMX 255, these
sliders should be at 10 position.
4) Once the scene is satisfactory, tap the Record button to program the scene as
step into the memory.
5) Repeat step 3 and 4 until all desired steps have been programmed into
memory. You may program up to 1000 steps into memory.
6) Select a chase bank or scene master to store your program. Tap the Page
button select a page (Page 1-4) to store your scenes.
7) Press a Flash button between 25-48 while holding down the Record button. All
LED will flash indicating the scenes have been programmed into memory.
8) You can continue programming or exit. To exit Program mode, tap the Exit
button while holding down the Record LED should go out.
EXAMPLE: Program a 16 steps chase with channel 1-32 at full in sequence I
nto Flashbutton 25 of Page 1.
1) Record enable.
2) Push Master A & B to maximum position and Fade silder to top.
3) Tap the Mode Select button to select 1-48 Signle mode.
4) Push Channel slider 1 to the top position, its LED light at full intensity.
5) Tap the Record button to program this step into memory.
6) Repeat steps 4 and 5 until you've programmed Channel sliders 1-32.
7) Tap the Page button causing Page 1 LED lights.
8) Tap the Page button 25 while holding down the Record button, all LEDs
will flash indicating you've programmed the chase into memory.
2. Editing
2.1 Edit Enable
1) Record enable.
2) Use the Page button to select the page the program you wish to edit is
on.
3) Tap the Mode Select button to select CHNS
TR-SRL-574
SCENES.
Pag. 7
English