Triton Blue 24/48 TR C 2448 Manual De Usuario página 10

5) To return to normal mode, tap the Audio button a second time causing its
LED goes out, the Audio mode is disengaged.
3.3 Running a Programs With the Speed Slider
1) Be sure the Audio mode is disengaged, that is the Audio LED goes out.
2) Select your program as described above.
3) Move the Speed slider to the SHOW MODE position (the botton), then tap
the Flash button (25-48) while pesssing and holding down the Rec Speed
button, the corresponding program will not run with the Standard beat any
longer.
4) Now you may move the Speed Slider to select your desired speed.
NOTE: The step 3 is not necessary if the selected program is not recorded with
Standard Beat.
3.4 Running a Programs With the Standard Beat
1) Be sure the Audio mode is disengaged. Tap the Mode Select button to
select CHNS
2) Tap the Park button to select Mix Chase mode, the LED lights indicating
this selection.
3) Select your program as described above.
4) Move the Speed slider until Segment Display reads your desired value.
You may tap the Tap Sync button twice to define your beat time.
5) While pressing and holding down the Rec Speed button, tap the Flash
button(25-48) that stores the program.
6) The program will then run with the set time or beat when engaged.
7) Repeat steps 4 and 5 to set a new beat time.
4. Chang the Speed Mode between 5 Minutes and 10 Minutes
1) Press and hold the Record button.
2) Tap the Flash button 5 or 10 three times while holding down the Record
button.
3) The 5 MIN or 10 MIN should light up indicating the Speed slider is set to
run in the 5 or 10 minute mode..
5. MIDI
5.1 Setting MIDI IN
1) Tap the Flash button 1 three times while holding down the Record button,
the Segment Display reads "CHI" indicating MIDI IN channel setup is
available.
2) Tap the Flash button numbered from 1-16 to assign MIDI IN Channel 1-
16, the relevant channel LED lights indicating MIDI IN channel is set.
5.2 Setting MIDI OUT
1) Tap the Flash button 2 three times while holding down the Record button,
the Segment Display reads "CHO" indicating MIDI IN channel setup is
available.
2) Tap the Flash button numbered from 1-16 to assign MIDI OUT Channel 1-
English
SCENE mode.
Pag. 10
TR-SRL-574