INSTRUCTIONS
1. Remove loose dirt from the surfaces that you want to clean (use a brush or vacuum cleaner).
2. Connect the air cleaning gun to a compressor. Check the state of the couplings and the hoses.
3. Turn the black tilting lever to the vertical position in order to activate the cleaning fluid in the bottle.
4.
Important: keep the outlet opening at a distance of approx. 3 cm in front of the surface to
be cleaned.
5. Press the trigger and slowly move the air cleaning gun in circular movements above the surface to
be cleaned.
6. Turn the black tilting lever into the horizontal "no air" position, press the trigger and dry the
surface.
7. Possible remnant moisture on the cleaned surface can be wiped away using a soft and dry cloth.
8. Clean the grommet as follows: turn the black tilting lever into the horizontal "no air" position, hold
the cleaning nozzle in a bucket and press the trigger in order to remove all soiling from the nozzle.
TROUBLESHOOTING (power loss)
Probable cause
Dirty or
blocked air ducts
Insufficient air supply
Leakage
Check O-rings and seals
Tool insert
ENVIRONMENTAL PROTECTION
Recycle undesired substances instead of disposing them as waste. All tools,
accessory parts and items of packaging must be sorted, taken to a recycling centre
and disposed of in an environmentally friendly manner.
DISPOSAL
Dispose of this product at the end of its service life in accordance with the disposal
provisions of your region. Ask your local waste disposal authority about recycling
measures.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Lubricate tool, drain compressor and feed lines
Increase air pressure. Ensure that the compressor meets air volume
and pressure requirements
Use Teflon tape to seal all fittings and connectors
Replace worn or damaged parts if necessary
Ensure that the tool can meet the requirements.
Tel.: 02196 720480
Fax.: 02196 7204820
Rotating nozzle
Solution
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed