HoMedics enviraScape BELIEF Manual De Instrucciones página 3

ASSEMBLY INSTRUCTIONS:
Item includes: Fig. 1
A-Base
B-Pump
C-Adaptor
D-Fountain Top
E-Rocks
1. unpack the product. Be sure that all parts listed are included.
2. Familiarize yourself with the water pump (B). the speed (Fig. 6) is
controlled by the switch located at the front of the pump. the speed
is indicated by a plus (+) and minus (-) sign. to increase the speed,
move the switch slowly in the direction of the plus sign. at its high-
est speed level, the switch will not move any further. to decrease the
speed, move the switch toward the minus sign. Similarly, at its low-
est speed, the switch will not move any further.
NOTE: it is recommended the pump be set at its highest speed dur-
ing assembly and later adjusted to a lower setting if desired. Be sure
to unplug the pump before adjusting the speed setting.
3. place the base on a flat surface, and lead the pump cord through
the cord slot on the bottom of the base (Fig 2). this will ensure that
the unit is balanced when placed on a flat surface.
4. insert the pump outlet into the water tube so that the fountain top
stands on the base securely
5. Fill the base with clean water up to the level of the platform surface.
place the river rocks on the platform and in the bowl for decoration
(Fig 3).
6. plug the cord into 120V household outlet. the fountain is controlled
by the switch located on the power cord, if pump doesn't operate,
rotate in-line switch once to turn on and once more to turn off.
NOTE: Ensure that the electrical cord loops below the electrical out-
let to form a "drip loop". this will prevent water from running down
the cord into the electrical outlet (Fig 4).
NOTE: For best results, be sure the pump is completely submerged
at all times.
4
Fig. 1
Platform
Clean Water
A. Base
Fig. 2
Flat Surface
Base
Fig. 3
Clean Water
D. Fountain top
E. rocks
Switch
C. adaptor
B. pump
Switch
Switch
adaptor
rocks
5