Kohler K-T9493 Instrucciones De Instalación página 6

CAUTION: Risk of scalding hazard. Do not turn the
thermostatic mixing valve stem after you adjust the
temperature setting until you install the mixing handle
trim. This device has been calibrated at the factory to
ensure a safe maximum water temperature. Any
variance in settings or water inlet conditions from
those used during factory calibration may raise the
discharge temperature above the safe limit, and may
present a scalding hazard.
K-400: Turn on the water supply lines to the valve, and
check for leaks. Run water through the mixing valve and
all showers and the spout, and check the system for
leakage. Turn off the water.
K-401: Remove the plaster guard. Do not turn the
thermostatic mixing valve stem until you have installed
the handle trim.
Turn on the water supply lines to the valve, and check for
leaks. Run water through the mixing valve and all showers
and the spout, and check the system for leakage. Use the
volume control/shut-off valve (top control) to control the
water flow to the shower outlet. Turn off the water.
Reinstall the plaster guard.
Complete the finished wall.
ADJUST TEMPERATURE SETTINGS
This valve has been calibrated at the factory to provide
104_ F (40_ C) water at the mixing valve's first stop
position. The maximum temperature limit stop has been
adjusted so the maximum water temperature will not
exceed 120_ F (49_ C).
NOTE: The listed water temperature settings are based
upon the following factory conditions:
S
Hot and cold water pressure = 43.5 psi (3.05
kg/cm@)
S
Hot water temperature = 149_ F (65_ C)
S
Cold water temperature = 59_ F (15_ C)
If the actual water supply conditions differ significantly
from those listed, you may need to re-calibrate the valve.
A
1012606-2-
Mixing
Valve Stem
Hot Water
Supply Line
6
Volume
Control/Shut-off
Valve
Cold Water
Supply Line
Fig. #6
Kohler Co., Kohler, WI U.S.A.