Sartorius YDO01C-232 Instrucciones De Instalación página 17

Configuring the Interface
Configure the UniCOM universal data
interface for the desired operating
mode by selecting the corresponding
settings in the operating menu of
the indicator (i.e., for connection of
a peripheral device or printer).
The illustration on the left shows the
relevant section of the operating menu.
RS-485/RS-422 Interface
If the PCB is configured for the
RS-422 operating mode, the "SBI" and
"xBPI-232" menu items are available.
Analog Interface
Select menu settings to define which
value is output and how error messages
are shown.
– Output value:
Net value (factory setting)
or
Gross value
– Error display:
High level (20 mA) (factory setting)
or
Low level (0/4 mA): With this setting,
there are 5 V on this interface during
operation
The selection of Min. and Max. values
lets you define the weighing range for
output from the 0/4 to 20mA current
interface.
The Min. and Max. values are always
defined in kilograms. You can enter
negative values if desired. You can also
specify a Min. value that is greater than
the Max. value, if descending current
output is desired.
Examples:
Ascending current curve
Min. value, net: -1 kg
Max. value, net: 4 kg
Descending current curve for
xBPI balance
Min. value: 5 kg
Max. value: 1 kg
Descending current curve for
SBI balance
Min. value: 5 kg
Max. value: 1 kg
Profibus Interface
Set the bus address in the operating
menu (0 to 126, factory setting: 126).
Ethernet Interface
Enter the required numbers in the
UNICOM menu under Ethernet
> Source IP, Ethernet > ListenPort, etc.
Under "Source name" you can enter
letters and numbers. Enter up to
15 characters.
Port numbers
Range: 0 – 65535
Because many of the ports up to 49150
are already allocated, we recommend
using numbers higher than 49150.
This does not apply for Modbus/TCP,
as port number 502 is used here (see the
operating instructions for the field bus
module). Profibus/ Ethernet Interface:
Initialization
17