Storing The Machine - Stihl FS 300 Manual De Instrucciones

English / USA
: Place spring with frame in position
– check that outer spring loop (8) is
correctly seated.
: Use a suitable tool to push the
spring into the housing. Apply tool
through the openings (see arrows).
The frame slips off in this process.
If the spring pops out and uncoils during
installation: Refit it in the spring housing
in the counterclockwise direction – start
outside and work inward.
: Fit the screw.
: Install the rope rotor as described in
"Replacing the Starter Rope".
: Tension the rewind spring.
: Fit the fan housing.
38
FS 300, 350
8
: Take out the screws (9).
: Remove the spring housing and
parts of old spring.
: Lubricate the new spring spring in
the new spring housing with a few
drops of non-resinous oil (Special
Accessories).
: Fit new spring with spring housing –
bottom plate must face up.
If the spring pops out and uncoils during
installation: Refit it in the spring housing
in the clockwise direction – start outside
and work inward.
: Fit the screws.
: Install the rope rotor as described in
"Replacing the Starter Rope".
: Tension the rewind spring.
: Fit the fan housing.
9
9

Storing the Machine

For periods of about 3 months or longer
: Drain and clean the fuel tank in a
well ventilated area.
: Dispose fuel properly in accordance
with local environmental
requirements.
: Run engine until carburetor is dry –
this helps prevent carburetor
diaphragms sticking together.
: Remove, clean and inspect the
cutting tool.
: Thoroughly clean the machine – pay
special attention to the cylinder fins
and air filter.
: Store the machine in a dry, high or
locked location – out of the reach of
children and other unauthorized
persons.
FS 300, FS 350, FS 400, FS 450, FS 480