Fueling; Fitting The Harness - Stihl FS 300 Manual De Instrucciones

Fueling

Before fueling, clean the filler cap and
the area around it to ensure that no dirt
falls into the tank.
Always thoroughly shake the mixture in
the can before fueling your machine.
In order to reduce the risk of burns
or other personal injury from
escaping gas vapor and fumes,
remove the fuel filler cap carefully
so as to allow any pressure build-up
in the tank to release slowly..
After fueling, tighten down the filler
cap by hand as securely as
possible.
FS 300, FS 350, FS 400, FS 450, FS 480
Change the fuel pickup body every
year.
Before storing your machine for a long
period, drain and clean the fuel tank.
Run the engine until the carburetor is
dry.
English / USA

Fitting the Harness

2
3
: Put on the full harness (1).
: Adjust length until the spring hook
(2) is about a hand's width below
your right hip. Over-long straps can
be cut to length after making the
adjustments.
: Attach the spring hook to the
machine's perforated strip (3).
Find the right attachment point for the
cutting tool you are using – see section
"Balancing the Machine".
1
27