Stihl FS 300 Manual De Instrucciones página 38

2
3
4
: Thread the rope through the rotor
and secure it in the rotor with a
simple overhand knot.
: Lubricate the rope rotor bearing
bore with non-resinous oil (Special
Accessories).
: Slide rotor onto starter post – turn it
back and forthe until the loop of the
rewind spring engages.
: Fit the pawl (4) and washer (3), and
press the spring clip (2) into
position.
The spring clip must point counter-
clockwise and engage the peg on
the pawl.
FS 300, FS 350, FS 400, FS 450, FS 480
Tensioning the Rewind Spring
: Make a loop in the unwound starter
rope and use it to turn the rope rotor
six full revolutions in the direction of
the arrow (see illustration).
: Hold the rotor steady – straighten
the twisted rope.
: Seilrolle loslassen
: Release the rotor and let go of rope
slowly so that it winds onto the rotor.
The starter grip must sit firmly in the
rope guide bush. If the grip droops
to one side: Increase spring tension
by one additional turn.
When the starter rope is fully extended
it must be possible to rotate the rotor at
least another half turn (FS 300, 350) or
one and a half turns (FS 400, 450, 480)).
English / USA
If this is not possible, the spring is
overtensioned and could break.
: Take one turn of the rope off the
rotor.
: Fit the fan housing.
Replacing the Rewind Spring
Broken parts of the spring may still
be under tension and could be
thrown in your direction when you
pull off the rope rotor and remove
the spring housing. To reduce the
rist of injury, wear eye and face
protection and work gloves for the
following operations:
: Remove the rope rotor as described
in "Replacing the Starter Rope".
FS 400, 450, 480)
: Remove screw from the outer spring
loop.
: Remove parts of old spring.
: Lubricate the new spring with a few
drops of non-resinous oil (Special
Accessories).
37