Function Test; Switching On The Device - geberit AquaClean Tuma Comfort Instructions De Montage

EN

Function test

Switching on the device

WARNING
Hazardous voltage
Danger of electric shock due to water on
exposed live parts.
4 Mount the removal limiter (safety rope)
between the device and mounting plate
before switching it on.
4 After switching the device on for the first
time, do not shake or tilt.
4 The device contains water. Before
removing the removal limiter for service
purposes, switch off the device using
the power switch.
Prerequisite
– The device has been mounted and connected.
– The removal limiter is correctly engaged on the
mounting plate.
– The water supply at the ball valve has been
opened.
– The spray shield has been mounted.
1
Switch on the device at the power switch.
ü After about 5 seconds, the LED on the
lateral control panel flashes blue. The
device initialises.
ü The device performs pre-rinsing.
ü After the completion of the switch-on
procedure, no LEDs are lit. The device is
in economy mode.
2
Insert the WC lid.
If the LED flashes red, the device is
defective. Do not attempt any device repairs.
Inform customer service.
20
Simulating a user
For the following test steps, contact must
be maintained with the WC seat as shown
in order to simulate a user.
• The LED on the lateral control panel will
light up blue.
4
Simulate a user. Place a hand flat on the
marked position and leave it lying flat.
ü The LED on the lateral control panel
lights up blue and the odour extraction
unit runs. A user is detected.
ü The WC seat heating starts.
The odour extraction unit stops and the
LED goes out if no hand is detected on the
WC seat.
• Economy mode is active.
18014400418479371-1 © 05-2017
967.305.00.0 (01)