JANE nurse cruiser Manual Del Usuario página 19

GB
cruiser
B. When used for (100-135 cm) (6-10 level use)
When the child grows to a height of over 1 metre, the headrest height should be set to level 6-10.
REMOVE AND STORE THE METAL PLATE AWAY (1.7 C) and slide first the left strap and then the right
strap. Now you can remove the shoulder straps. (See 1.7)
From the front part of the car safety seat, pass the shoulder straps through the slots and place them
underneath the fabric cover.
After removing them, remove the METAL PLATE from the plastic part and store it away. Pull the
headrest height adjuster until reaching the correct height for the shoulder belt and release the
adjuster to set the height in the correct position for the child.
ATTENTION!
A correctly adjusted headrest ensures optimal protection for your child in the safety seat:
The headrest must be adjusted so that the shoulder straps are at the same level as your child's shoulders.
Adjust the headrest to the proper position, so that the distance between the shoulder of the child and
the bottom of the headrest can be lowered by one finger.
CAUTION! The shoulder straps must not run behind the child's back, at ear height or above the ears.
1.4 Adjust Safety Belt Lengthen
A Tighten Safety Belt
Pull up shoulder belt and the lap belt will tighten, then pull crotch belt to tighten safety belt.
Tighten the safety belt as much as possible without causing discomfort to the child. The lap belt is as
low as possible and should put near child's crotch not abdomen.
P.S.: Loose safety belt is dangerous. Please check safety belt adjuster whether work, then tighten
safety belt. After tightening the seat belt, adjust the shoulder pads to the appropriate position on
the chest.
B Loosen Safety Belt
When press the safety belt adjuster, the other hand must grasp the safety belt which under shoulder
pads and pull it forward to release the safety belt.
1.5 Adjust the Rotation of the Seat
Pull the rotation adjuster out with your thumb, then rotate the safety car seat to 360 degree angle.
(see picture a)
ACTION: Each time rebound the rotation adjuster back. To make sure the seat is fixed well.
A. Rearward Direction: (40-105cm), must use rearward direction (see picture 1)
B. Forward Direction: (76-135cm), must use forward direction (see picture 2)
C. When the seat is rotated to 90 degrees, the user can place the child in this position, but he/she
cannot use this angle during driving (see picture 3).
1.6 Adjust the Angle of the Child Safety Car Seat
Push the recline handle up and pull the seat outward (see picture a), then the seat can be adjusted.
It can be adjusted to 4 positions for forward-facing use (see picture ).
When the seat is in the position of fourth level, rotate the seat to the rearward direction, and the seat
can be adjusted to fifth level.
Different height need use different recline levels.
40-105cm: rearward facing installation, use fifth level (see picture )
76-105cm: forward facing installation, use first level to fourth level ( see picture to picture )
100-135cm: forward facing installation, use first level (see picture )
Note: Do not use forward facing before the child's age exceeds 15 months.
Installation of
Installation of forward facing
rearward facing
0-3 years
18 months-3 years
100-135 cm
3-12 years
5
Fifth Level (Lying Level) First Level Second Level Third Level Fourth Level
Note: Do not use forward facing before the child's age exceeds 15 months
19