Typical Installation - Homewerks 7107-03HW Manual Del Usuario

DIMENSIONS
Ceiling
Opening (L) Opening (W)
10-13/16 in.
WIRING
All wiring must be connected for full functionality.
Automatic terminal switch
Capacitor for
Motor
long life of
motor
House
Wires

TYPICAL INSTALLATION

Properly insulate
around fan to
minimize building
heat loss and gain
Fan housing
Seal any gap
around fan
housing
Homewerks.com
Ceiling Ceiling
Opening (H)
10-1/2 in. 8-1/2 in.
to 120V AC 60Hz
Black wire
White wire
Green wire
Junction box
FAN HOUSING
Quick Connector
Product Wires
Short piece of
flexible duct helps
alignment and
absorbs sound
2-3 foot straight
run before
elbow
Housing
Dimension (L)
10-1/4 in.
WARNING: Wiring must comply with all
applicable electrical codes. Turn off power
before removing or installing connectors.
To switch
To neutral
WARNING: COPPER TO COPPER ONLY.
Do not use aluminum wire.
To ground
CAUTION: Accessory part (quick connector)
should meet installation instructions below.
NOTE: The connector is reusable on solid
wires of the same wire gauge or smaller. Do
not reuse the connector on stranded wires.
• Strip wires 3/8 in. - 1/2 in.
• Grip the wire firmly and push the stripped end of the
wire into the open port of the connector. Use only one
conductor per port.
• Verify the stripped end of the wires is fully inserted to the
back of the connector.
CAUTION: Wiring maximum temperature rating
221˚F (105˚C). 600V maximum for building wiring
and 1,000V maximum for signs and light fixtures.
The acceptable wire range is 18-16 AWG Sol. Cu.
The ducting from this fan to the outside of the building
Roof cap
has a strong effect on the airflow, noise and energy use
(with built-in
of the fan. Use the shortest, straightest duct routing
damper)
possible for best performance, and avoid installing the
fan with smaller ducts than recommended. Insulation
around the ducts can reduce energy loss and inhibit
Caulk
termination
mold growth. Fans installed with existing ducts
to duct
may not achieve their rated airflow.
Wall cap
(with
built-in
damper)
5
Housing Housing
Dimension (W) Dimension (H)
10-1/4 in. 8 in.