Homewerks 7107-03HW Manual Del Usuario página 8

INSTALLATION INSTRUCTIONS (Continued)
10. Position the fan housing (A) so the bottom edge of the fan
housing (A) is flush with the ceiling board. Do not flush
mount the fan housing (A) to the joist.
Attach the end of each of the suspension brackets (C, D, E)
to the ceiling joists using wood screws (AA).
11. Secure suspension brackets (D, E) to the fan housing (A)
using machine screws (BB) and suspension bracket (C) to
the fan housing (A) using a machine screw (CC).
12. Reattach the duct connector to the fan housing (A) with the
screws that were set aside when the duct connector was
removed earlier.
13. Remove the wiring box cover from the fan housing (A). Pull
the house wires through the hole in the wiring box cover.
Using the quick connectors, connect the house wiring from
the wall switch to the fan housing (A). 14 AWG is the
smallest conductor that should be used for branch circuit
wiring. Please refer to the wiring diagram on page 5 to
ensure proper wire connections are made. Carefully push
the wire connections into the wiring box and reattach the
wiring box cover.
CAUTION: If the house electrical wires do not match the
colors from the fan wiring diagram on page 5, you must
determine what each house wire represents before
connecting. You may need to consult an electrical
contractor to determine safely.
10
AA
D
11
C
CC
E
12
13
Wiring
Cover
8
A
E
C
A
Quick
Connector
A
Homewerks.com
BB
D
A
Wiring
Cover