Tabla de contenido
en
General regulations
The appliance is suitable
S for refrigerating and freezing food.
S for making ice.
The appliance is intended for domestic
use only.
The appliance is suppressed according to
EU Directive 2004/108/EC.
The refrigeration circuit has been checked
for leaks.
This product complies with the relevant
safety regulations for electrical appliances
(EN 60335/2/24).
Installing the appliance
Installation location
The appliance should be installed in a dry,
well ventilated room. The installation
location should neither be exposed to
direct sunlight nor near a heat source,
e. a cooker, radiator, etc. If installation
next to a heat source is unavoidable, use
a suitable insulating plate or observe the
following minimum distances to a heat
source:
3 cm to electric or gas cookers.
30 cm to an oil or solid fuel cooker.
22
Connecting the
appliance
After installing the appliance, wait at least
1 hour until the appliance starts up.
During transportation the oil in the
compressor may have flowed into the
refrigeration system.
Before switching on the appliance for the
first time, clean the interior (see Cleaning).
The socket should be freely accessible.
Connect the appliance only to 220-240 V/
50 Hz AC current via a socket which has
been properly installed. The socket must
be fused with a 10 to 16 A fuse.
If the appliance is to be operated in a
non European country, check on the
rating plate whether the indicated voltage
and current type correspond to the values
of your mains supply. The rating plate is
situated in the bottom left hand side of
the appliance. The power cable must only
be replaced by a technician.
Tabla de contenido
