MSA Gallet F2XR Manual De Instrucciones página 11

GB
5.3 Rear Neck Protector (GA3709)
Installation
Removal
5.4 Headlamp
If the headlamp is removed from the helmet, the following components should be installed.
Front plate (GA3707) to replace front module, and rear cover (GA3706) to replace the rear module.
5.5 Lamp Holder F2XR (GA3710)
A lamp holder (left or right side) can be installed on the accessory interface to receive an MSA helmet
mounted flashlight.
Installation
Removal
5.6 Hearing Protection Accessories (MSA & SORDIN Adapters 14)
The helmet's accessory interface includes a slot to install hearing protection earmuffs (left and right side).
WARNING!
Hearing protection accessories are not suitable for activities with a risk to flame exposure (e.g. wildland
firefighting) and only suitable for non-firefighting associated activities such as wood cutting, road clearance,
etc.
Failure to follow this warning can result in serious personal injury or death.
Refer to the Hearing Protection user manual supplied with the accessory.
(1) Place the neck curtain upside down above the
helmet.
(2) Insert the central clip (B).
(3) And continue with (A) and (C).
(1) To remove the neck protector, release the clips
by pressing them.
(1) Insert the lamp holder, the accessory interface
slot until it clicks.
(1) Push the release button inside the helmet and
simultaneously pull the lamp holder out.
5 Gallet F2XR Accessories
11