Troubleshooting - Klarstein Glacial Manual Del Usuario

EN
24

TROUBLESHOOTING

Fault Inspection
Ice maker is Power switch
unable to start.
Power plug
Control panel fuse
Ice storage bin
Power supply
Wasserhahn
Inlet valve
The compressor is Power supply
unable to start or
stops abruptly.
Air inlet
Condenser
Refrigerating
system
Compressor
Cause Solution
In the OFF Turn the power
position switch to the ON
position.
Not plugged into Plug the mains
the socket plug into the
socket.
Faulty or Check and
damaged replace
The ice storage Remove the ice
bin is full and the or remove the ice
ice is pressed from the blades of
against the blades the evaporator.
of the evaporator.
No electricity or Contact your
voltage is too low electricity supplier.
No water or Increase the water
water pressure is pressure.
too low
The filter is Clean the filter or
clogged or the replace the inlet
water valve is valve.
faulty.
Voltage is too low Contact your
electricity supplier.
The air inlet is Keep a distance
blocked. of at least 15 cm
to the left and
right sides and the
rear.
Too much dust Clean the
condenser.
Refrigerating Contact
system leakage constumer service.
The connection Contact
cable is broken or constumer service.
defective.