Changing The Amount Of Coffee In The Cup; Adjusting The Coffee Grinder; Making Espresso With Pre-Ground Coffee (Instead Of Beans); Running Off Hot Water - Whirlpool ACE 102 IXL Instrucciones Para El Uso

CHANGING THE AMOUNT OF COFFEE IN THE CUP

The appliance is factory-set to automatically deliver the following amounts of coffee:
• Espresso,
• Small cup,
• Medium cup,
• Large cup,
• Mug. To modify these quantities and set the amount of coffee desired, for example changing the amount of espresso, proceed as
follows:
• Press the button
• Keep the button
runs off coffee.
• Press the button
The machine is now reprogrammed with the new setting and is ready for use.
You can also modify the amount of coffee in a small cup, medium cup, large cup and mug.
N.B.: press button (B9) for a measure of coffee which is double that previously set using button
If you wish to return to the original machine settings, see paragraph Resetting factory default values (reset).

ADJUSTING THE COFFEE GRINDER

The coffee grinder is factory-set and does not require adjustment; nonetheless, if run-off is too fast or too slow (coffee drips out),
carry out an adjustment using the grinding coarseness adjustment knob (Figure 14).
WARNING
For slower run-off and creamier coffee, turn the knob 1 click in an anti-clockwise direction (=finer ground
coffee).
For faster run-off (not in drips), turn the knob 1 click in a clockwise direction (=coarser ground coffee).

MAKING ESPRESSO WITH PRE-GROUND COFFEE (INSTEAD OF BEANS)

• Press button (B3) (Figure 8) and select the pre-ground coffee function.
• Slide the machine out towards you; be sure to use the purpose-designed handles (Figure 7).
• Lift the small central lid, pour one scoop of pre-ground coffee into the funnel (Figure 18); push the machine back inside
the housing and proceed as described in chapter MAKING COFFEE (USING COFFEE BEANS).
N.B.: only one coffee at a time can be made, press button
• If, after operating the machine with pre-ground coffee, you want to revert to making coffee with beans again, deactivate
the pre-ground coffee function by pressing button
N.B.:
• Never add pre-ground coffee when the machine is switched off, as it could spread throughout the inside.
• Never add more than 1 scoop, otherwise the machine will not prepare the coffee.
• Use only the scoop provided.
• Only use pre-ground coffee for espresso coffee machines.
• If you add more than one scoop of ground coffee and the funnel becomes blocked, carefully use a knife to clear the coffee
through the funnel (Figure 20), then remove and clean the brewing unit and the machine as described in paragraph
Cleaning the brewing unit.

RUNNING OFF HOT WATER

• Always check that the machine is ready for use.
• Check that the water spout is attached to the nozzle (Figure 6).
• Place a container under the spout.
• Press OK (B7).
The display shows HOT WATER and hot water runs out of the spout, filling the container below (Do not run off hot water
for more than 2 minutes at a time). To stop the flow, press the button
set quantity of water has been dispensed.
(B4) repeatedly until the display shows ESPRESSO.
(B8) pressed until the display shows the message PROGRAM QUANTITY. Meantime the machines
(B8) again to stop run-off and reprogram the machine with the new quantity of coffee.
The adjustment knob must only be turned while the grinder is in operation.
(B8) (Figure 12).
(B3) (Figure 8) again.
(B11). Run-off stops automatically when the pre-
GB32
(B8).