Using The Appliance For The First Time; Switching On And Preheating - Whirlpool ACE 102 IXL Instrucciones Para El Uso

USING THE APPLIANCE FOR THE FIRST TIME

• Coffee has been used to factory test the machine and it is therefore completely normal for there to be traces of coffee in
the mill.
• Customize water hardness as soon as possible, following the instructions in paragraph Setting water hardness.
1. Connect the appliance to the mains power supply. Set the desired language.
2. Scroll using the buttons
PRESS OK TO INSTALL ENGLISH, press the OK button (B7) (Figure 3). If you select the wrong language, follow the
instructions in paragraph Setting the language. If, on the other hand, your language is not available, select one of those
displayed. English is the reference language for the instructions. Next, follow the instructions indicated on the display.
After 5 seconds, the display shows FILL TANK !: remove the water tank (Figure 4), rinse and fill to the MAX line with fresh 3.
water then replace in the machine.
4. Place a cup underneath the hot water spout (Figure 5). (If the water spout is not inserted, the appliance displays the
message INSERT WATER SPOUT !: insert it as shown in Figure 6. The display shows HOT WATER. PRESS 'OK' . Press OK (B7)
(Figure 3) and after a few seconds, water runs out of the spout.
The display shows TURNING OFF. PLEASE WAIT... and switches off. 5.
6. Slide the machine out, using the handles provided (Figure 7); open the lid, fill the coffee bean container, then close the lid
and push the machine back into the housing.
The coffee machine is now ready for normal use.
WARNING
N.B.:
• When using the appliance for the first time, you need to make 4/5 cups of coffee and 4/5cappuccinos before the
appliance gives good results.
• Each time the machine is turned on using the main ON/OFF switch (A23) it runs the SELF-DIAGNOSIS function and then
switches off: to switch back on again, press the (A7) on/stand-by button (Figure 1).

SWITCHING ON AND PREHEATING

Each time the machine is switched on, it performs an automatic preheat and rinse cycle which cannot be interrupted. The
machine is ready for use only after completion of this cycle
WARNING
To switch the appliance on, press the (A7) on/stand-by button (Figure 1): the display shows HEATING UP. PLEASE WAIT.... After
heating, the display shows another message: RINSING. The machine is at working temperature when the display shows
MEDIUM CUP STANDARD TASTE.
(B5 and B6) until you find the desired language (Figure 2). When the display shows:
Never place pre-ground coffee, freeze-dried coffee, caramelized coffee or foreign objects
in the container, as they could damage the machine
Risk of burns! During rinsing, some hot water is run off from the coffee spouts.
GB30