Synchronization Of Hands To The Time "T1; Pilot Functions; Pilot Chrono; Data Logging - Hamilton KHaki Flight Timer Manual De Instrucciones

3. Instructions for use
3.15 Synchronization of the hands with time
zone "T1"
Desynchronization of the hands and the digital time is
possible when the battery is changed or with a violent
shock. It is recommended to adjust the digital time "T1"
before synchronizing the hands.
Synchronizing the hands
1. In position (p1) turn the crown to access the digital
display with no values indicated except for the date
display (if activated) at 3 o'clock.
2. Pull the crown out to position (p2). The display
indicates "Synch" and the digital time flashes.
3. Turn the crown to adjust the hours hand.
4. Press button to switch to the minutes hand and
B
the seconds hand.
5. Push the crown back to position (p1) to confirm the
settings.
INSTRUCTION MANUAL

4. Pilot functions

Pilot chrono

4.1
This specific function logs the key stages of a flight or
flights. It is possible to memorize up to 20 flights of 99
cycles each. After the operations, a "Logbook" allows
restoration of the data. A simplified illustration of the
functioning of these operations is presented on the
cover of this manual.
Definitions
Block time ("bloc" on the screen): The block time starts
when the airplane moves for the first time from a sta-
tionary position, and finishes when the airplane reaches
a final stationary position with all motors stopped.
Cycle ("Cyc" on the screen): Landing and takeoff within
the same block time.
"VFR/IFR": The "VFR" (Visual Flight Rules) conditions are
applicable to visual flight, "IFR" (Instrument Flight Rules)
to flying on instruments. By default, the watch logs the
flight in "VFR" mode.

Data logging

4.2
Starting a block time
1. In position (p1) turn the crown to access the display
"bLoc T" or "bL CLo".
2. A double press on button
timing and the display indicates "bL Run".
starts the first block
C
13