Care And Cleaning - Kohler 25198-CP Instrucciones De Instalación

Care and Cleaning

Do not use any abrasive or harsh cleaners to clean the faucets.
For best results, keep the following in mind when caring for your KOHLER product:
Always test your cleaning solution on an inconspicuous area before applying to the
entire surface. Visit kohler.com/clean for KOHLER brand faucet cleaner products.
Wipe surfaces clean and rinse completely with water immediately after applying
cleaner. Rinse and dry any overspray that lands on nearby surfaces.
Do not allow cleaners to soak on surfaces.
Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush
or scouring pad to clean surfaces.
Upon cleaning other areas of the restroom be sure the sensor lenses are protected
from other cleaning chemicals/solvents to prevent potential damages to the sensor
and/or electronics.
It is recommended to flush the system with warm water every 2 to 3 months.
Remove and clean the nozzle foaming assembly with warm water.
Remove and clean the check valve from the dispensing tube in the soap reservoir
with warm water.
Fill the soap reservoir with minimal amount of clean warm water.
Reattach the soap reservoir to the control box. Press the system prime button.
Hold the button down until all of the water has been flushed through the system.
Refill the soap reservoir with the appropriate foaming hand soap. Press and hold
the system prime button until all residual water is pushed through the pump and
soap is dispensed.
Kohler Co. 21
1419479-2-A