Chapter2. Machine Installation; Transport And Positioning; Environmental Conditions; Electrical Connections - Minipack-Torre Tunnel 50 Digit Instrucciones Para La Instalación, Uso Y Mantenimento

Chapter2. Machine installation

2.1. Transport and positioning

It is recommended to handle with great care during transport and positioning!
Use protection gloves while handling the machine.
!
Cut the strap with scissors make sure you protect your eyes by wearing glasses and withdraw the cardboard (figure
2.1.A page 51).
!
Remove the roller plate (19).
!
Unscrew the 4 fastening screws (A) to the pallet, putting the 4 plates (B) back inside the machine.
!
Using a fork lift, remove the tunnel from its pallet (figure 2.1.B page 51) and level it on the ground.
!
Position the roller plate (19), coupling it to the conveyor belt (figure 2.1.C page 51).

2.2. Environmental conditions

!
Place the machine in a suitable environment free from humidity, gases, explosives, combustible materials.
!
Leave a minimal space of 200mm around the machine so that not to obstruct air outlets (figure 2.2. page 51).
!
Once the correct height is abtained, block the machine by means of the wheel brakes.
Working environmental conditions:
!
Temperature from + 5°C to + 40°C
!
Relative humidity from 30% to 90%, without condensation
The lighting of the operation room shall comply with the laws in force in the country where the machine is installed.
However, it shall be uniform and provide for good visibility in order to safeguard the operator's safety and health.
MACHINE SAFETY FACTOR = IP20
THE AERIAL NOISE MADE BY THE MACHINE IS LOWER THAN 70 dB

2.3. Electrical connections

OBSERVE HEALTH AND SAFETY REGULATIONS
If the machine is not equipped with the power supply plug, use a plug that is suitable for the voltage and
amperage values described by the rating plate and that can comply with the rules in force in the installation
country.
GROUNDING OF THE UNIT IS OBLIGATORY! (figure 2.3. page 52).
Before executing electrical connections, make sur that the mains voltage matches the one on the plate on rear machine
and that the ground contact complies with the safety rules in force. In case of doubts about the mains voltage, contact
the local public supply Company.
10