Husqvarna 587960201 El Manual Del Propietario página 7

INSTALLING BAGGER MOUNT
1. To select the right support straps to use, measure
the mower frame just behind the casters, as shown.
NOTE: For frames measuring 26" use support straps
A, for frames measuring 23" use support straps B.
B
A
2. Install the bagger mount tube to the rear guard with
5/16-18 x 3 1/4 bolts and flange nuts from kit.
3. Install kit support straps on the outside of the mount
tube as shown in the illustration. Using a 5/16-18
x 1 1/4 bolt, attach the front side of the strap to the
fender support, inserting a spacer between the
mower and the strap. Donot add flange nut at this
time. Place the reinforcement plate to the outside of
the fender support. Secure with additional 11/4 bolt
and fasten both bolts with flange nuts.
Repeat steps on opposite side.
ASSEMBLY
NOTE: The front side of the kit support straps should
be on the inside of the mower frame.
4. Tighten all hardware.
Reinforcement Plate
Support
Strap LT
Mount Tube
CHUTE SUPPORT
1. Position upper chute support against bagger inlet,
flush at outer edges. See Illustration.
2. Using support as a template, drill two 3/8" holes
into bagger hood.
Spacer
Upper Chute Support
Support
Strap RT
7