Husqvarna 587960201 El Manual Del Propietario página 8

1. Secure upper chute support to hood with hex bolts,
washers and nyloc nuts.
INSTALLING WEIGHT KITS
1. Bolt plate weight to weight brackets using four 3/8
16 x 3 bolts and nuts.
2. Remove the two bolts securing the footrest to the
frame.
3. Slide both weight brackets over the front tube on
the frame. Be sure to position the weight assembly
in the center of the frame.
4. Secure with two 3/8-16 x 3 1/2 bolts and nuts.
MOUNTING COVER ASSEMBLY
NOTE: For ease of assembly, you may wish assistance
from another person for mounting the cover assembly
to mower.
1. Lift and rotate cover to align the cover brackets with
support assembly tubes.
8
ASSEMBLY
Flex Trim
Front Tube
3 1/2" Bolt
Weight
Bracket
Weight
Assembly
3" Bolt
3/8-16 Nut
2. Slide the cover down over the support tubes until
secure.
MOUNTING CONTAINERS
1. Remove the end caps from the center two bag
support arms. Fully insert spacer plugs into the
ends of the support tubes. It may be necessary to
tap the spacers into place with a hammer or mallet
Replace the plastic end cap back over the spacer.
2. Install containers on support frame, overlapping
containers at center tube.
3. Close cover and lock latch handle over support
tubes.
NOTE: One container should always overlap the other
container at the center tube.