Setting The Time And Date - Victorinox Swiss army NIGHT VISION Guia De Inicio Rapido

LIGHTING FUNCTIONS
G
E
H
Fig. 1

SETTING THE TIME AND DATE

B
C
D
Fig. 2
All manuals and user guides at all-guides.com
F
A
I II III
LIGHTING FUNCTIONS (fig. 1)
Pusher:
E. Pusher
Lighting indications:
F. Blue LED light
G. White LED light
H. Red LED locator beacon
1. Dial illumination Mode: One quick
push of the pusher (E) activates the
soft blue LED light (F) for 6 seconds.
To deactivate, press the pusher (E)
once.
2. Extended Light Mode: Two quick
pushes of the pusher (E) activate the
white LED light (G).
3. Signal Mode: Three pushes of the
pusher (E) will cause the white LED
light to flash at 150 pulses/min. for
2 minutes.
Note: To deactivate Mode 2 / 3 prior to
2 minutes, press the pusher (E) once.
SETTING THE TIME AND DATE (fig. 2)
Timepiece indications:
A. Hours
B. Minutes
C. Seconds
D. Date
1. Pull out the crown to position III.
The seconds hand (C) will stop.
2. Turn the crown to the desired time.
Remember the date advances at
12:00 midnight, not 12:00 noon.
3. Push the crown back to position I.
4. Pull out the crown to position II
(the watch continues to run).
5. Turn the crown clockwise to the
desired date.
6. Push the crown back into position I.
Note: To avoid any damage to the
movement, do not perform the DATE
SETTING between 9:00 p.m. and
3:00 a.m. when the date mechanism
is in action.
4. SOS Signal Mode: Holding the
pusher (E) for 5 seconds will activate
an intensified SOS light signal.
To deactivate, press the pusher (E)
for 5 seconds.
5. Locator Mode: Red LED locator
beacon (H) blinks once every 10
seconds. Five pushes of the pusher
(E) will deactivate the Locator
Mode. Five pushes of the pusher will
activate it again.
6. Battery End-of-Life Mode (EOL): Red
LED locator beacon (H) will flash 3
times every 10 seconds indicating the
lighting batteries should be changed.