POST-ASSEMBLY
FINAL INSTALLATION CHECKLIST
❏ Ensure that the grill is properly assembled.
❏ At least 36" (91-cm) clearance must be maintained from combustible constructions to the
sides and back of the grill.
❏ There is no combustible construction material
over the grill.
❏ All internal packaging is removed.
❏ Burners are sitting properly on orifi ces as shown
in Fig.11. The orifi ce of the valve must be located
in the center of the burner section after removal
and cleaning. Otherwise, it may cause serious
bodily injury and property damage. Rock the
burner slightly after replacing to check whether
it has been installed properly.
❏ Knobs turn freely.
❏ The regulator and hose connected to the grill are provided by the manufacturer (preset for
11" [28-cm] water column).
❏ Unit tested and free of leaks.
❏ User informed of gas supply shut-off valve location.
VERY IMPORTANT: ALWAYS INSPECT THE HOSE PRIOR TO EACH USE.
IMPORTANT:
Lid must be open when lighting burners. TURN OFF GAS supply when not in use.
BEFORE LIGHTING:
• Inspect the gas supply hose before turning the gas ON. If there is evidence of cuts, wear,
or abrasion, it must be replaced before use. The replacement hose assembly must be that
specifi ed by the manufacturer.
TO LIGHT MAIN BURNERS OF THE GRILL:
Read instructions before lighting.
1. Open the lid and make sure all knobs are in the "OFF" position
before turning the valve on at the gas tank.
2. Push and turn the knob slowly counterclockwise to the ignite
position (
) as shown in Fig. 12. Keep pushing until the burner
lights and then release. Repeat for additional burners.
3. If burner does not light, immediately turn the control knob to the
"OFF" position and repeat Step 2.
4. If burner does not light after Step 3, TURN OFF GAS SUPPLY and
WAIT 15 MINUTES for the gas to disperse; then repeat Steps 1
and 2 or light with external fl ame. If problem persists, go to match-lighting instructions.
22
GRILL LIGHTING INSTRUCTIONS
Fig. 11
Fig. 12