Tabla de contenido
Idiomas disponibles
Idiomas disponibles
CONNECTING
THE DRAIN
HOSE
° The drain hose should always be properly secured. Failure to
properly secure the drain hose can result in flooding
and property
damage.
° Do not install the end of the drain hose higher than 96 in. (243.8
cm) above the bottom of the washer.
° The drain must be installed in accordance
with any applicable
local codes and regulations.
° Make sure that the drain hose is
not
stretched,
pinched, crushed,
or kinked.
NOTE:
A drain hose extension kit is
available
if the drain hose is not
long enough. Do not extend the
drain hose more than 6 feeh as
this will cause poor draining,
which will result in poor wash
and spin performance.
Option
1 : Standpipe
Elbow
Bracket
Strap
\
84:
Drain Hose
_,/
Install the end of the drain hose into the elbow bracket.
Do not extend the drain hose more than 4 inches past
the end of the elbow bracket. Use a tie strap to secure
the drain hose in place.
NOTE:
* Total height of the hose end should not exceed 96 in.
(243.8 cm) from the bottom
of the washer.
* The drain hose should be inserted no more than 8-12
inches into the standpipe.
Inserting more than 8-12
inches can cause mold or microorganisms
to spread to
the inside of the washer.
Option :2: Laundry
Drum
Tie Strap
Drain Hose
The elbow bracket should be installed near the end of
the drain hose. Hang the end of the drain hose over the
side of the utility sink. Use a tie strap to secure the drain
hose in place.
Option 3: Floor Drain
Drain Hose
\
Floor Drain
Insert the end of the drain hose into the floor drain.
If possible, secure the hose to prevent it from moving or
coming out of the drain.
CONNECT
TO THE POWER SUPPLY
Washer should be plugged into a 120-VAC, 60-Hz
grounded
3-prong outlet.
Plug in the washer.
J
10
Tabla de contenido
