Matrix R30 Manual Del Usuario página 4

A Open HARDWARE FOR STEP 1.
1
B Carefully pull the CABLES (1) through the CONSOLE
MAST (2) using the LEAD WIRE (3) located inside
the CONSOLE MAST (2). Discard the lead wire.
R30 Attach the CONSOLE MAST (2) to MAIN FRAME
C
(4) using 4 BOLTS (A) and 4 SPRING WASHERS (B).
R50
Torque settings: 23.1 Nm / 17 lb-ft.
Note: Be careful not to pinch any wires while attaching
the console mast.
Hardware For Step 1
Description Qty
3 B
A Bolt 4
B Spring Washer 4
1
2
4
6
MX16_AG_Bikes_ENG_FRE_SPE_r1_1.indd 6-7
A Open HARDWARE FOR STEP 2.
2
B Slide TOP CAP REAR COVER (5) over
CONSOLE MAST (2) and snap into place.
C Slide TOP CAP FRONT COVER (6) over
R30 CONSOLE MAST (2) and snap into place
D Attach HANDLEBARS (7) to CONSOLE MAST (2)
R50
using 2 BOLTS (C) and 2 SPRING WASHERS (B).
Torque settings: 23.1 Nm / 17 lb-ft.
Hardware For Step 2
Description Qty
A
C Bolt 2
B Spring Washer 2
7
B
5 C
R50 SHOWN
A Open HARDWARE FOR STEP 3
3
B Attach the SEAT FRAME ASSEMBLY (8) to the SEAT
SLIDE (9) using 4 BOLTS (D) and 4 SPRING WASHERS
(E). Torque settings: 23.1 Nm / 17 lb-ft.
R30 Connect the CABLES (10).
C
R50
Note: Be careful not to pinch any wires while attaching the seat frame.
Hardware For Step 3
Description Qty
D Bolt 4
E Spring Washer 4
D
E
2 6
8
10
9
A Open HARDWARE FOR STEP 4
4
B Attach the SEAT BOTTOM (11) to the SEAT FRAME
ASSEMBLY (8) using 4 BOLTS (F) and 4 SPRING
WASHERS (G).
R30 Attach the WATER BOTTLE HOLDER (12) to the
C
SEAT FRAME ASSEMBLY (8) using 2 SCREWS (H).
R50
Hardware For Step 4
Description Qty
F Bolt 4
G Spring Washer 4
H Screw 2
12
11
8
H
G
F
R50 SHOWN
7
3/10/16 2:03 PM