Tabla de contenido
Idiomas disponibles
Idiomas disponibles
5. Fan Assembly. (cont.)
With the hanging bracket secured to the outlet box and
able to support the fan, you are now ready to hang your fan.
Grab the fan firmly with two hands. Slide downrod through
opening in hanging bracket and let hanging ball rest on the
hanging bracket. Turn the hanging ball slot until it lines up
with the hanging bracket tab.
WARNING: Failure to align slot in hanging ball with tab in
hanging bracket may result in serious injury or death.
Tip: Seek the help of another person to hold the stepladder
in place and to help lift the fan up to you once you are set
on the ladder.
Find a secure attachment point (wood ceiling joist highly
recommended) and secure safety cable. It will be necessary
to use a heavy duty wood screw, washer and lock washer
(not supplied) with the safety cable loop. Adjust safety cable
length by loosening screw and nut on safety cable vice.
Adjust slack to a hand's length and tighten nut on vice
securely. The loop at the end of the safety cable should just
fit over the threads on the wood screw. Test safety cable by
pulling on loose end with pliers. If cable slips, then vice and
nut must be set tighter. Extra cable slack can be left in
ceiling area.
6. Wiring.
WARNING: Turn off circuit breakers to current fixture
from breaker panel and be sure switch is turned to the
OFF position.
CAUTION: Be sure outlet box is properly grounded and
that a ground wire (GREEN or Bare) is present.
Make sure all electrical connections comply with Local
Codes or Ordinances and the National Electrical Code. If
you are unfamiliar with electrical wiring or if the
house/building wires are different colors than those
referred to below, please use a qualified electrician.
Note: Excess lead wire length from the fan can be cut to
the desired length and then stripped.
When downrod is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect BLACK and BLUE wires from fan to BLACK
wire from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire from
ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together from fan
to BARE/GREEN wire from ceiling with wire connector
provided.
If you intend to control the fan light with a separate
light switch, connect BLUE wire from fan to the BLACK
(or RED) supply from the independent switch.
* Wrap each wire connector separately with electrical
tape as an extra safety measure.
wood ceiling joist
white supply wire
black supply wire
from
ceiling
black
white
white
black
blue
from fan
This fan is remote control adaptable
(remote control sold separately).
page 5
safety cable loop
wood screw
and washer
vice
safety cable
hanging bracket tab
hanging ball slot
motor housing
ground
(green or bare)
wire
connector
ground
(green
or bare)
*
Capítulos
Tabla de contenido
