5�6 Switching Channels On And Off; 5�7 Quick Adjustment Of The Final Temperatures; 5�8 Storing The Modelling Tips And Handpieces - Renfert Waxlectric I Manual De Instrucciones

5.6 Switching channels on and off
You can switch off the heat supply to channels that are not needed�
EN
• To do this, press the key
• To switch a channel that has been switched off back on, press the key
the display by the temperature setting�
Both the temperature setting and the channel that has been switched off are saved� This channel remains
switched off when the control unit is switched on again�
Also a switched-off channel can be saved as described in chapter 5.5.
5.7 Quick Adjustment of the Final Temperatures
Using this option, you can set the temperature of both channels directly to either the maximum or mini-
mum temperature when the unit is switched on�
Setting the minimum temperature:
• Switch the unit off�
• Press
• Press the on-off switch and keep it pressed�
- Once the unit of temperature is displayed (°C or °F), both channels are set to 50 °C (122 °F)�
Setting the maximum temperature:
• Switch the unit off�
• Press
• Press the on-off switch and keep it pressed�
- Once the unit of temperature is displayed (°C or °F), both channels are set to 200 °C (392°F)�
Any channels which are switched off (refer to Sec. 5.6) remain off and are not set to the minimum
or maximum temperature.
5.8 Storing the Modelling Tips and Handpieces
You can safely leave unused modelling tips in the tip holder for storage (Fig� 8)�
During breaks, you can safely leave unused handpieces in the quiver (Fig�9)�
NEVER insert the handpieces into the tip holder (Fig. 10). This can damage both the tip holder as
well as the control unit.
NEVER place the handpiece on a flammable surface or cover it! Fire hazard!
Tips and Notes
• In order to reduce the risk of breaking the probes, dip them into the hard wax block with the
rounded back section! The wax will melt more quickly and this allows to pick up a greater
amount of wax (Fig� 18)�
• More rapid and efficient modellation (time savings of up to 30 %!) can be achieved by pre-warm-
ing the wax in a Renfert Vario E� Wax can be processed more gently and cools more rapidly�
This reduces shrinkage to a minimum�
• Because the tip insert surfaces are not finished, they can – starting from their basic shape – be
ground, bent, or polished to suit your particular requirements�
• The handpiece cables can be guided through an appropriate retainer (eye, hook, etc�) to allow
the handpieces to hang down from above the work area at the ideal height� This "cable / hand-
piece overhead suspension" permits significantly faster handpiece access / changeovers.
• By setting the temperature at approx� 50 °C [122 °F], you can use the slightly warmed Waxlec-
tric blade to "shave" the wax crown edge onto the die while the wax is warm�
-
corresponding to the channel until „OFF" appears in the display�
-
key of the left channel and keep it pressed�
+
key of the left channel and keep it pressed�
- 8 -
+
until „OFF" is replaced in