Operation & Use - DHC BT2010 Manual Del Propietário

PREPARING TO TEST：
1. Be sure area around battery is well ventilated while battery is
being tested.
2. Clean battery terminals. Be careful to keep corrosion from coming
in contact with eyes.
3. Inspect the battery for cracked or broken case or cover. If battery
is damaged, do not use tester.
4. If the battery is not sealed maintenance free, add distilled water in
each cell until battery acid reaches level specified by the manu
-facturer. This helps purge excessive gas from cells. Do not overfill.
5. If necessary to remove battery from vehicle to test, always remove
ground terminal from battery first. Make sure all accessories in the
vehicle are off to ensure you do not cause any arcing.
OPERATION & USE:
INSERTION OR REPLACEMRNT OF LEAD WIRE
1. Remove the cover on the backside bottom of the battery tester.
2. Insert the connectors which contain a black-yellow pair and
a yellow-red pair in one end of the lead wire into the sockets which
can be found when you remove the cover as above. Be sure to make
the colors match between the connectors and sockets as shown
below.
black
white
yellow
red
- 3 -
BT2010 backside