Midea MDT24H3AST Manual De Instrucciones página 28

2.
The molded end of the drain hose will fit
(2.5 cm) diameter connections on an air gap, waste tee or disposal. Cut
on the marked line as required for your installation.
(2.5 cm)
NOTE: Use
two hose ends. Secure the connection with hose clamps if an extension is required.
3.
Secure the drain hose to the air gap, waste tee or garbage disposal
with clamps.
Option 1 – (Garbage Disposal - With Air Gap):
1.
Remove the knockout drain plug from the disposal inlet. Using a
screwdriver and hammer, firmly tap the plug. The plug will separate
and fall into the disposal.
28
2.
Remove the drain plug from the disposal.
IMPORTANT: If you need to cut the drain hose to fit the diameter of
the connection, cut only the rubber end of the hose, as shown earlier in
this section (do not cut into the ridged section).
3.
Using a screw-type clamp*, attach the drain hose to the air gap. Cut
the rubber end of the hose, as needed.
a a
1" 3/4" 5/8"
/ " / "
3 5
1" 4 8
(1.9 cm) (1.6 cm)
5/8 7/8
" or " inside diameter hose and a coupler to connect the
a b
a
a
5/8
" (1.6 cm),
a
Cutting
Lines
a
a
Disposal Inlet
a
Disposal Drain Plug
3/4
" (1.9 cm) or 1"
a
Hose Clamp
b
Coupler